Advertisement
IDENTIFY COMPONENTS. Packed
separately within the carton you will find
all supplied items which are to be
attached to the telephone set housing
throughout these Instructions. Remove
HANDSET
HANDSET CORD
LINE CORD
4
eadh item from its pro&c&e packaging
before beginning the instatlation
procedures (The wall-mount kit shown
below Is an optional item available from
your telephone supplier).
Bracket Assembly
The optional NTCC22l5 Wall-Mount Kit
(A0342537) Includes a wedge-
shaped
for attachment to the
base of the set. Complete installation
instructions (pO696509) accompany
the kit,
HANDSET INSTALLATION --
STEP 1
right side of telephone set as shown in
Fig. A.
Ensure plug Is properly seated audible
click) and installed in the correc jack.
STEP 2
Grasp the handset and the opposite end
of the handset cord as shown in
Fig. R
Fully insert the plastic plug at the end of
cord into the jack located at end of
handset. (An audible click lndlcates the
plug is properly seated In the jack).
WARNING: Do not insert the plug at the
free end of the handset cord direct& into
a wall or baseboard jack. Such misuse
may result In unsafe sound levels
DESK-TOP APPLICATION
STEP 1
Complete HANDSET INSTALLATION
(Fig. A and B).
STEP 2
Place the telephone set as shown In Fig. C
and carefully slide the plug at either end
of the line cord into the lack orovided 6t
the back of set. (An audible click ln@cafes
the plug is properly seated in the jack).
STEP 3
Properly installed handset and II& cords
for a desk-top installation are shown in
Fig. D.
STEP 4
Place fully assembled telephone sit (base
down) in location required and insert plug
located at opposite end of line cord into
shown in Fig. E.
Place handset on hook. Check for dial
tone by lifting handset off-hook and
listening.
Fig. C
Advertisement
