Rio RIO09HP115V1A Installation, Service & Troubleshooting page 109

Warning - Wait 10 minutes after power is disconnected before starting disassembly.
6. Open electrical box
Step 1. Disconnect the cable clamp
Step 2. Remove the temperature sensor. Disconnect
the connection wires. Remove the screw from the
evaporator. Remove wires from terminals.
Note: Take care not to lose the thermistor clip.
Pat attention to the mounting of the thermistor,
replace in exact manner.
Step 3. Remove the screw holding the electrical box
to the chassis, remove electrical box.
Disassembly of RIO Indoor Unit
12,000 btuh Other models may vary slightly
109