Lennox ADAGIO-MN Care And Operation Instructions Manual page 10

1. Place the rear log (A) as shown in Figure 8
the bottom of the log over the corresponding locating pins (#1 & #2)
and against the log support bracket. See Figure 7 for pin and rear
bracket locations.
Figure 8 - Install Rear Log (A)
2. Place the left middle log (B) as shown in Figure 9
on the bottom of log B over the corresponding locating pin on Log A.
B
Figure 9 - Install Left Middle Log (B)
3. Place the left front log (D) as shown in Figure 10
on the bottom of log D over pin# 3.
D
D
Figure 10 - Install Left Front Log (D)
10
Position the 2 holes on
.
A
1


4
5
Position the hole
.
A
Position the hole
.

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
4. Place the right front log (E) as shown in Figure 11
on the bottom of log E over pins #4 and # 5.
Figure 11 - Install Right Front Log (E)
5. Place the right middle log (C) as shown in Figure 12
C behind Log E and resting on the "flat" on Log A.
Figure 12 - Install Right Middle Log (C)
6. Ember Placement - Separate the Embers (rockwool) into pieces
about the size of a quarter (see Figure 7). Keep the pieces fluffed up,
not matted. Distribute these pieces over the surface of the burner, as
shown in Figure 13. Do not use more than is necessary. Ensure that
the main burner ports remain uncovered by the ember material.
Figure 13 - Ember Placement
Position the hole
.
E
Position log
.
C
A
E
DO NOT place ember material directly
over the ember burner ports.