Dish Network 301 IR 123271 Manual page 7

Downloaded from www.Manualslib.com
1. For DISH 322 receivers only: If you are using a 4.0 Remote
control with the green 1 UHF Pro key installed, perform the
steps a. through e. below. If not, then go to step 2.
a. Open the TV1 UHF Pro Setup screen by pressing
MENU-6-1-8 on the remote control.
b. Select Enable from the TV1 UHF Pro Setup screen.
c. Press the SYS INFO button to open the System
Information screen.
d. Move the highlight to the address for the Primary Remote
Address as shown below. This is important - if you do not
do this, your remote will change the receiver's Secondary
Remote Address and cause your Remote Control 1 to
control the
e. Go to step 3 below.
2. Open the System Information screen. Consult your receiver
user's guide for instructions on how to open this screen without
using the remote control. The System Information screen
will show either one Remote Address, or it may show a
Primary Remote Address and a Secondary Remote
Address.
Note: On the DISH 322, leave Done highlighted.
3. Press and hold the SAT mode button about three
seconds, until all the mode buttons light up,
and then let go of the SAT button. The SAT mode
button will blink.
4. Use the number buttons to enter any number
from 1 to 16. The SAT mode button goes out after you enter
each digit, and then lights up again.
Write down the number you entered:
6
manuals search engine
side of your receiver.
Do not do this step if you are using 4.0
Remote with blue 2 key. This will cause your
Remote Control 2 to control
receiver.
Note: Highlight
the Primary
Remote
Address if you
are using a 4.0
remote with a
green 1 UHF Pro
key.
side of your