Before You Begin Programming Homelink - Dodge Challenger 2014 Owner's Manual

182 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
The HomeLink® buttons that are located in the overhead
console designate the three different HomeLink® chan-
nels.
HomeLink® Buttons
NOTE: HomeLink® is disabled when the Vehicle Secu-
rity Alarm is active.
Before You Begin Programming HomeLink®
Ensure your vehicle is parked outside of the garage
before you begin programming.
For efficient programming and accurate transmission of
the radio-frequency signal it is recommended that a new
battery be placed in the hand-held transmitter of the
device that is being programmed to the HomeLink®
system.
Erase all channels before you begin programming. To
erase the channels place the ignition in the ON/RUN
position and press and hold the two outside HomeLink®
buttons (I and III) for up to 20 seconds. The Electronic
Vehicle Information Center (EVIC) will display "CLEAR-
ING CHANNELS." Release the buttons when the EVIC
displays "CHANNELS CLEARED."