Figure 6-8 System: Dhcp Setup; Table 6-2 System: Dhcp Setup - ZyXEL Communications NetAtlas IES-1000 User Manual

NetAtlas IES-1000 (AAM1008) EMS User's Guide
The following table describes the labels in this screen.
LABEL
DHCP Relay Configure the fields below to set the DHCP relay settings.
Service
Relay Select Yes to enable DHCP relay. Otherwise, select No to disable this feature.
Relay Option82 You cannot leave this field blank.
Enable DHCP relay info to have the IES add the originating slot and port numbers to client
TCP/IP configuration requests that it relays to a DHCP server.
Relay Option82 Use this field to specify up to 24 ASCII characters of additional information for the IES to add to
Info the DHCP client TCP/IP configuration requests that it relays to a DHCP server.
An example would be the chassis number of the IES or the ISP's name.
Apply Click Apply to save the changes.
DHCP Server This table displays the IP address(es) and status of the DHCP servers.
You can configure up to three DHCP servers.
Server IP This field displays the IP address(es) of the DHCP server(s) to which the IES should relay
Address DHCP client TCP/IP configuration requests.
Active This field shows whether a DHCP server is enabled (Yes) or not (No).
New Click New to add a new DHCP server entry in the Create a DHCP Server screen.
Delete Click Delete to remove the selected DHCP server entry.
Close Click Close to close this screen.
6-6

Figure 6-8 System: DHCP Setup

Table 6-2 System: DHCP Setup

DESCRIPTION
The System Menus