Connect The Wiring; Install Light Bulbs - Broan QML Series Instruction Manual

Hide thumbs Also See for QML Series:
Table of Contents

Advertisement

Available languages

Available languages

CONNECT THE WIRING

GROUND
SCREW
Connect House Power Cable to range hood wiring -
22
BLACK to BLACK, WHITE to WHITE, and GREEN or
BARE WIRE to Ground Screw. Replace electrical wiring
box cover.
23
Re-connect lamp wire harness and re-attach bottom panel
with (8) screws as shown in Step 10.

INSTALL LIGHT BULBS

HALOGEN
BULB
(2)
ROTATE
CLOCKWISE
CAUTION: Bulbs may be hot. Always allow bulbs
to cool before removing them.
Install (2) Halogen Bulbs. Use 120 V, 35 W, shielded
24
halogen bulbs - MR16 with GU10 base.
NOTE: Suction Cup Tool (included with hood) can be
used to install and remove light bulbs.
Align pins on bulb with large diameter opening on socket,
then push bulb in towards hood and rotate clockwise until
firmly seated.
The position of the bulb socket (depth) is adjustable and
may require adjustment when:
a) certain brands of bulbs are difficult to install.
b) the bulb protrudes too far below the light panel.
HOUSE
POWER CABLE
SUCTION
CUP TOOL
(1)
PUSH IN
LIGHT PANEL
LAMP SOCKET
BRACKET
To change the depth of bulb sockets:
- Remove bottom panel (See Step 10).
- Disconnect light harness.
- Loosen 2 Screws holding Lamp Socket Bracket to
Light Panel.
- Adjust socket/bracket to desired depth.
- Re-tighten screws securely.
- Re-attach light harness and replace bottom panel.
DUCTED INSTALLATION ONLY:
25
Re-install aluminum filters removed in Step 9.
NON-DUCTED INSTALLATION ONLY:
Install non-ducted filter - purchased and assembled in
Step 15.
QML SERIES
Page 6
SCREWS

Advertisement

Table of Contents
loading

Table of Contents