Dolby Digital Or Dts Decoder - Harman Kardon DVD25 Owner's Manual

Setup and Connections
Connecting to a receiver/amplifier with Dolby Digital (AC-3) or DTS (Digital Theater Systems) decoder
When DVD´s encoded in Dolby Digital or DTS are
played, the Dolby Digital or DTS bitstream is out-
put from the player's OPTICAL or COAXIAL digi-
tal audio output. When the player is connected
to a Dolby Digital or DTS decoder, you can enjoy
theater-quality audio in your home. An optical
digital audio cable or coaxial audio cable (both
optional) is required for these connections, as
shown below. Only one connection is needed,
not both at the same time.
(Red/White, optional only, see Note above)
To Video input connector
DVD 25
VIDEO OUT/COMPONENT
To coaxial audio input connector
To optical audio input connector
Front Speaker (Left/Right)
I Note: With multiple video sources, your
Audio/Video device can be used for selecting
the video signal and routing it to the TV.
Connect the video or S-video output of the
DVD 25 (whatever is provided with your
device) to the video or S-video input on your
device and the video/S-video output of this
device to your TV. For more details, see the
manual of your Audio/Video amplifier/receiver.
To S-Video input connector
To audio input connector
(Yellow)
Y / Y / G
TV SCART
Pb/ Cb/ B
Pr/ Cr/ R

Dolby Digital or DTS decoder

Center Speaker
I Note for Analog Audio: The connection
TV
Surround Speaker (Left/Right)
from Audio Out to the TV is optional only.
Normally you´ll hear the sound from your AV-
system´s speakers, so the TV volume should
be completely turned down. If you plan to use
your DVD 25 also without having to turn on
your complete system, this connection must
exist, then you can turn up the TV´s volume as
needed.
To power outlet
(AC 230V/50 Hz)
/60
20
CLASS 1 LASER PRODUCT
KLASSE 1 LASER PRODUKT
LUOKAN 1 LASER LAITE
KLASS 1 LASER APPARAT
Subwoofer
SETUP AND CONNECTIONS 11