Miele FN 35402 i Operating And Installation Instructions page 47

Information in the display
Problem
The alarm symbol ;
flashes in the
display.
The warning tone
sounds and the
power cut symbol t
appears in the
display.
The temperature
display will show the
warmest
temperature
recorded in the
freezer during the
power cut or
interruption to the
power supply.
Possible cause
The temperature in the
freezer has risen higher or
fallen lower than the
temperature which has
been set. This could be due
to:
– the appliance door has
been opened frequently.
– a large quantity of food
was placed in the freezer
section at once without
switching on
SuperFreeze.
– the power was cut for a
long time.
The temperature in the
appliance in the previous
days or hours has risen too
high because of a power
cut or interruption to the
power supply.
The appliance will go back
to the last temperature
setting when the power is
back on.
Problem solving guide
Remedy
^ Remedy the alarm. The
alarm symbol ; will
disappear and the
audible tone will stop.
Depending on the
temperature, check
whether the food has
defrosted or started to
defrost. If this is the case,
cook the food before
freezing again.
^ Touch the alarm off
sensor.
The warmest temperature
will be deleted. The display
will then revert to showing
the current temperature in
the freezer.
^ Depending on the
temperature displayed,
you should check the
condition of food in the
freezer. If it has defrosted
or started to defrost,
check that it is still safe to
use and, if so, use it as
soon as possible.
Defrosted food may only
be refrozen after it has
been cooked.
47