Asus A7V266-EX User Manual page 37

3. HARDWARE SETUP
13) Infrared Module Connector (10-1 pin IR_CON)
This connector supports an optional wireless transmitting and receiving infrared
module. This module mounts to a small opening on system cases that support
this feature. You must also configure the setting through UART2 Use Infrared
(see 4.4.2 I/O Device Configuration) to select whether UART2 is directed for
use with COM2 or IrDA. Use the five pins as shown in Back View and connect
a ribbon cable from the module to the motherboard SIR connector according to
the pin definitions. (NOTE: The SIR module is not supplied with the
motherboard. The CIR module is currently not available.)
A7V266-EX
A7V266-EX Infrared
Module Connector
14) ASUS iPanel Connector (24-1 pin AFPANEL)
This connector supports an optional ASUS iPanel, an easy to access drive bay
with front I/O ports, status LEDs, and space reserved for a hard disk drive.
Alternatively, if not using an ASUS iPanel, connect an optional wireless
transmitting and receiving infrared module to the SIR connector, or an optional
consumer infrared connector set for wireless transmitting/remote control functions
through one external infrared module.
A7V266-EX
A7V266-EX Front Panel Connectors
ASUS A7V266-EX User's Manual
R
AFPANEL
SIR
CIR
IR_CON
R
Standard Infrared (SIR)
Front View Back View
SIR
CIR
IRTX
GND
IRRX
Standard Infrared (SIR)
Front View Back View
IRTX
GND
IRRX
+5V
(NC)
+5V
(NC)
37