Asus P4P800-F User Manual page 32

2. Floppy disk drive connector (34-1 pin FLOPPY1)
This connector supports the provided floppy drive ribbon cable. After
connecting one end to the motherboard, connect the other end to the floppy
drive. (Pin 5 is removed to prevent incorrect insertion when using ribbon cables
with pin 5 plug).
P4P800-F
P4P800-F Floppy Disk Drive Connector
3. ATX power connectors (20-pin ATXPWR1, 4-pin ATX12V1)
These connectors connect to an ATX 12V power supply. The plugs from the
power supply are designed to fit these connectors in only one orientation. Find
the proper orientation and push down firmly until the connectors completely fit.
In addition to the 20-pin ATXPWR1 connector, this motherboard requires that
you connect the 4-pin ATX +12V power plug to provide sufficient power to the
CPU.
Make sure that your ATX 12V power supply can provide 8A on the +12V lead
and at least 1A on the +5-volt standby lead (+5VSB). The minimum
recommended wattage is 230W, or 300W for a fully configured system. The
system may become unstable and may experience difficulty powering up if the
power supply is inadequate.
P4P800-F
P4P800-F ATX Power Connector
ASUS P4P800-F motherboard user manual
FLOPPY1
®
PIN 1
ATXPWR1
+3.3VDC
-12.0VDC
COM
PS_ON#
COM
COM
COM
-5.0VDC
+5.0VDC
®
+5.0VDC
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.
ATX12V1
+12V DC GND
+3.3VDC
+3.3VDC
COM
+5.0VDC
COM
+12V DC GND
+5.0VDC
COM
PWR_OK
+5VSB
+12.0VDC
1-21