Toshiba e-STUDIO 207L Quick Start Manual page 16

Chapter 1 PREPARATIONS
Saving energy when not in use – energy saving modes –
This equipment supports three energy saving modes; the Automatic Energy Save mode, Sleep mode and Super Sleep
mode. The table below shows the procedures to switch modes manually and the conditions under which the equipment
enters into or recovers from each mode.
Energy saving Procedure to switch
modes
When a specified period of
Automatic
time
Energy Save
last use of the equipment.
mode
• When the [ENERGY
SAVER] button
pressed.
Sleep mode • When a specified period
of time
the last use of the
equipment.
• When the [ENERGY
SAVER] button
pressed.
Super Sleep
• When a specified period
mode of time
the last use of the
equipment.
*1 The default value set at the factory shipment is 1 minute.
*2 Any of the [START], [ENERGY SAVER], [COPY], [e-FILING], [SCAN], [PRINT] and [FAX] buttons.
*3 [ENERGY SAVER] button on the control panel.
*4 The default value set at the factory shipment is 1 minute (The default value set at the factory shipment of the European version is 10 minutes).
*5 Any of the Wireless LAN Module and e-BRIDGE ID Gate.
*6 Any of IPX, AppleTalk and other protocols. When the IPsec function is enabled, the equipment enters into the Sleep mode. For details, refer to the
following guide:
& TopAccess Guide (PDF): "Chapter 8: [Administration] Tab Page" - "[Setup] Item list"
*7 When a paper exit option such as the Finisher is not installed, the equipment will return to the super sleep mode immediately after print data are
output.
For changing the set period of time for entering into each mode, refer to the following guide:
& MFP Management Guide (PDF): "Chapter 2: SETTING ITEMS (ADMIN)" - "GENERAL"
For the European version
Contact your service representative to change the default settings noted above.
When the set period of time for switching to the Automatic Energy Save mode is the same as that for the Sleep mode or
the Super Sleep mode, the equipment enters into the Sleep mode or the Super Sleep mode after the set period of time.
If an original is placed on the original glass during the energy saving mode, its size will not be detected even when the equipment
is recovered from this mode. After pressing the [START] or [POWER] button to recover from the mode, such as when "READY" is
displayed on the basic copying function menu, place it on the glass again.
14
Conditions to enter into
modes
has passed since the
*1
• When a particular option
is is installed.
*3 *5
• When a particular
protocol
has passed since
*4
When a particular option
is is not installed and also
*3
when a particular protocol
*6 is disabled.
has passed since
*4
Status of equipment
the mode
"Saving energy - press
START button. " appears on
—
the touch panel.
The touch panel display
goes off and the [ENERGY
SAVER] button lights in
is enabled. green.
*6
Only the MAIN POWER
*5
lamp (green) lights.
Conditions to recover
from the mode
• When a button on the
control panel is pressed.
*2
• When print data or fax
data are received.
Same as the Automatic
Energy Save mode.
• When the [POWER]
button is pressed.
• When fax or print data
*7
through a wired LAN or a
USB cable are received.
• When the time set in
Scheduled Print has
come.