4. OPERATING YOUR ENGINE
STARTING
STOP SWITCH
1
ON
OFF
Set the throttle lever to the idling
■
position.
If the stop switch is installed on the
■
engine.Set the stop switch to the
position "ON or I ".
If the stop switch is installed on a
■
machine side.Set the stop switch to
the position "ON or I ".
CHOKE LEVER
2
Close the choke lever.
If the engine is cold or the ambient
■
temperature is low, close the
lever
fully.
If the engine is warm or the ambient
■
temperature is high, open the
choke lever
half-way, or keep it
fully open.
3
ON
4
choke
- 8 -
PRIMER PUMP
Push the primer pump 7 to 10 times
to feed the fuel to the carburetor.
RECOIL STARTER
Pull the starter handle slowly, until
■
resistance is felt.
This is the "compression" point.
Return the handle to its original
position and pull swiftly.
Do not pull out the rope all the way.
■
After starting the engine, allow the
■
starter handle to return to its
original position while still holding
the handle.