1. Remove the four screws.
2. Unhook the upper side of the unit, then open
the case from the upper side.
3. Be sure not to lose the bright knob, then remove the case.
4. Remove the two screws on the linear
PCB, then disconnect between the linear
and digital PCBs.
5. Disconnect the wire for the back light and the flat
cable for the LCD, then remove the linear PCB.
DISASSEMBLY
Screw
Screws
Digital PCB
— 6 —
Screw
Hooks
Bright knob
Linear PCB
Screws
Flat cable
Wire