Connect Dc Power - Pioneer XW-LF3-T Operating Instructions Manual

Connect DC Power

• Connect the AC adapter's USB-A
connector to unit's USB-microB
connector with bundled USB cable.
Then connect the power plug on the
other end to the power outlet.
• Start to charge the internal battery
automatically. (150 min for full charge)
• The unit can play the music even though
it is in charging status. The amount of
time it takes to reach full charge will
increase.
Power
outlet
Caution
• Ensure that you only use the AC adaptor
and USB cable provided with the unit.
Connecting an AC adaptor with different
specifications to the unit may prevent
the internal battery from charging
correctly, or lead to malfunctions or
damage.
Important
• Be sure to charge before using for the
first time.
• Approximately 150 minutes are required
to fully recharge the battery.
• A fully charged battery provides
approximately 4 hours of use at
maximum volume and approximately
7 hours at volume 10.
• Playing time with a fully charged battery
changes depending on functions used,
frequency of use, ambient temperature,
speaker volume and other factors.
• The furnished battery can be recharged
about 500 times, although it may be less
depending on conditions of use and
storage. If the time required to reach a
full charge increases substantially, or
playing time falls dramatically even after
charging, the battery pack is at the end
of its life. If you wish to replace the
battery pack with a new one, please
contact your nearest Pioneer authorized
service center.
• When the AC adapter is not connected,
the battery will slowly drain even when
the unit is in the standby mode.
If you are not going to use the unit for an
extended period of time, charging it
completely at least once every six
months will prevent the battery from
degrading. When doing this, the charge
may take longer than normal.
11
En