Product Identification - Desa H.S.I. Series Owner's Manual

PRODUCT IDENTIFICATION

Hot Air
Outlet
Lower Shell
Fuel Cap
Side Cover
Ignition Control Assembly
(assembly on inside of side cover)
Figure 1
ASSEMBLY
These models are furnished with wheels and
a front handle. Some models are furnished
with a rear handle also. Wheels, handle(s),
and the mounting hardware are found in the
shipping carton.
Tools Needed
• Medium Phillips Screwdriver
• 3/8" Open or Adjustable Wrench
• Hammer
1. Slide axle through wheel support
frame. Install wheels on axle.
IMPORTANT: When installing wheels,
point extended hub of wheels toward
wheel support frame (see Figure 2).
2. Place cap nuts on axle ends. Gently tap
with hammer to secure.
3. Place heater on wheel support frame.
Make sure air inlet end (rear) of heater is
over wheels. Line up holes on fuel tank
flange with holes on wheel support frame.
4. Place front handle (and rear handle if
provided) on top of fuel tank flange. In-
sert screws through handle(s), fuel tank
flange, and wheel support frame. At-
tach nut finger tight after each screw is
inserted.
5. After all screws are inserted, tighten
nuts firmly.
104018
Upper Shell
Power Cord
Screw
Hot Air
Outlet
Fuel
Tank
Flange
Wheel
Support
Frame
Wheel
Cap Nut
Figure 2 - Wheel and Handle Assembly
3
OWNER'S MANUAL
Fan Guard
Fuel Tank
Front
Handle
Nut
Axle
Rear
Handle
Air Inlet
Extended Hub