KTM 990 Adventure 2008 Owner's Manual page 86

TROUBLE SHOOTING
TROUBLE
Engine overheats
FI lamp is blinking / lights up
ABS warning lamp lights up
Engine stalls while driving
High oil consumption
Headlight and position light fail
»
CAUSE
Defect fan or thermoswitch for fan
Air in the cooling system
Thermostat defective
Error in the injection system (see
blink code)
Driving situation with extremely dif-
ferent wheel speeds
Fuse is blown
ABS sensor is loose or the cable
damaged
ABS sensor wheel is bent
Error in the ABS
No fuel
Fuse for fuel pump has blown
Engine oil level too high
Engine oil too thin (viscosity)
Bulb burned out
Blown fuse
REMEDY
Contact an authorized KTM workshop.
Bleed the cooling system (see Maintenance work)
Have the thermostat checked (opening temperature 75°C,
167°F) or replaced; contact an authorized KTM workshop
Visit an authorized KTM workshop
Stop, switch off the ignition, start again
Replace the ABS fuses (under the right engine cover)
Replace the ABS OPTIONAL fuse
Check the ABS sensors for a tight fit and the cable for dam-
age, visit an authorized KTM workshop
Visit an authorized KTM workshop
Visit an authorized KTM workshop
Refuel
Replace fuse FUEL PUMP
Check engine oil level when the engine is warm; correct if
necessary
Use thicker engine oil; see chapter „Engine oil"
Replace bulb
Replace fuse H/L BEAM POSITION.
85