Recessing The Appliance Into The Wall - Napoleon NEFL32FH Installation And Operating Instructions Manual

3.4

RECESSING THE APPLIANCE INTO THE WALL

Due to the many different fi nish materials used on walls, it is highly recommended that you consult your local
builder before you install this appliance in the wall.
Select a location that is not prone to moisture and is located at least 36" (914mm) away from combustible
materials such as curtain drapes, furniture, bedding, paper etc.
A. Measure the appliance and create a rough in with electrical.
B. Remove the front glass, refer to "FRONT GLASS REMOVAL" section.
C. Hold the appliance up to ensure it will fi t into the framing.
D. If the appliance is fully recessed into the wall:
• Bend the two top tabs upward on the front glass, Figure 4.
• Use the 6 screws (provided) to lock the appliance into the wall with the existing two side
fl anges, see Figure 2.
• Install the media and reinstall the glass front.
E. If partial recess into the wall:
• Use the two mounting brackets (supplied) to lock the appliance to the wall, see Figure 3.
NOTE: Two sets of holes are provided for recessing into wall. The wall structure may
limit how far the appliance can be recessed. Use the appropriate set of holes when
recessing to the frame, it may be necessary to use the four holes on the top and
bottom.
NOTE: It is recommended the walls of the appliance enclosure be fi nished (ie. drywall) to avoid
exposed insulation or vapour barrier coming in contact with the appliance. This will ensure clearance
to combustibles is maintained.
13
EN
W415-1542 / 08.26.15