Toshiba 58L9300 Series Owner's Manual page 25

NOTE:
On some cases, the reception of stereo/bilingual
broadcasts may not be possible after switching on the
e Mono 2 mode.
Adjusting the sound Balance
1
In the Sound menu, press  /  to select
Balance and press  /  to emphasize left and
right speaker balance.
Adjusting the Bass, Treble
1
In the Sound menu, press  /  to select Bass
or Treble.
2
Press  /  to change the setting.
Selecting the TV Mounting (Wall/Table)
Audyssey TV Mounting feature can provide an
appropriate sound depending on the TV installation
type, that TV is installed on a wall or a TV table.
1
In the Sound menu, press  /  to select
Audyssey Premium Television and press OK.
2
Press  /  to select TV Mounting.
3
Press  and  /  to select Wall or Table.
Using the Audyssey Dynamic Volume®
Audyssey Dynamic Volume® controls volume
levels to eliminate loud spikes and raise soft dialog
for more enjoyable television and movie viewing.
1
In the Sound menu, press  /  to select
Audyssey Premium Television and press OK.
2
Press  /  to select Dynamic Volume.
3
Press  and  /  to select Day, Night or Off .
Using the Audyssey ABX™
Audyssey ABX™ technology uses sophisticated
driver analysis and low frequency monitoring to
extend the range and bass of small speakers. This
enables the system to produce lower frequencies
that would be possible with a traditional system of
the same size.
1
In the Sound menu, press  /  to select
Audyssey Premium Television and press OK.
2
Press  /  to select Audyssey ABX.
3
Press  and  /  to select the desired
Audyssey ABX level (Low, High or Off ).
Using the TV's features
Using the Dynamic Range Control
This feature allows control of compression for Dolby
Digital.
1
In the Sound menu, press  /  to select
Dynamic Range Control.
2
Press  and  /  to select On or Off .
Selecting the TV Speakers On/Off
This feature allows you to turn the TV speakers off
when connecting the audio system.
1
In the Sound menu, press  /  to select TV
Speakers.
2
Press  and  /  to select Off .
To turn on the built-in speakers:
Select On in step 2.
Selecting the Headphone Settings
This setting is used to set the sound output when
headphones are connected.
Speaker
Link
On
Off
1
In the Sound menu, press  /  to select
Headphone Level and press OK.
2
Press  /  to select Speaker Link and press
 and  /  to select On or Off .
< Headphone Level
Speaker Link
Headphone Level
3
If you select Off , then select Headphone Level
and use  /  to adjust the headphone sound.
Headphone
Sound is output No sound
(2 ± is available.)
Sound is output Sound is output
(Headphone level (2 ± is available.)
menu is available.)
On
30
Speakers
On
Off
25