Ford 2014 Econoline Owner's Manual page 56

Keys and Remote Control
Replacing the Battery
Note: Refer to local regulations when disposing of transmitter batteries.
Note: Replacing the battery will not delete the remote control from your
vehicle. The remote control should operate normally after battery
replacement.
The remote entry transmitter uses one coin type three-volt lithium
battery CR2032 or equivalent.
To replace the battery:
4. Insert the new battery. Refer to the diagram inside the remote entry
transmitter for the correct orientation of the battery. Press the battery
down to ensure that the battery is fully seated in the battery housing
cavity.
5. Snap the two halves back together.
2014 Econoline (eco)
Owners Guide gf, 1st Printing, November 2012
USA (fus)
1. Twist a thin coin between the two
halves of the remote entry
transmitter near the key ring. Note:
Do not take the rubber cover and
circuit board off the front housing
of the remote entry transmitter.
2. Do not wipe off any grease on the
battery terminals on the back
surface of the circuit board.
3. Remove the old battery.
55