Dimplex DFR2551L Owner's Manual page 10

Operation
C. Heat ON/OFF
Cycles the unit sequentially
through the 3 settings: Low Heat,
High Heat and Off.
→ Activated by pressing the
button on the unit or the remote.
• Indicated by the
the (high heat) icon and the
intake temperature being dis-
played on the On Screen Display,
for 5 seconds before turning off.
! NOTE: After the heater is
switched off, there is a 60 second
fan delay, where the fan will con-
tinue running before turning off.
! NOTE: The unit can be oper-
ated in Heat Only Mode. When
the unit is only running with the
heater, the
(high heat) icon and the in-
take temperature will continuously
be displayed on the On Screen
Display.
! NOTE: The heater may emit
a slight, harmless odor when first
used. This odor is a normal condi-
tion caused by initial heating of
internal heater.
10
(low heat) or
(low heat) or the
D & E. Thermostat Controls
Adjusts the temperature set point
to your individual requirements.
Once the desired set temperature
is reached the heater will turn off.
The heater will cycle on and off
to maintain the desired set tem-
perature. The default temperature
setting is 72°F (22°C).
→ Adjusted by pressing the
to decrease the setpoint and
the to increase the setpoint
on the remote.
• The On Screen Display will in-
dicate the temperature setpoint
as it is adjusted.
! NOTE: Holding the
down, then press
will change the temperature from
°C to °F, or vice versa.
Disable Heat
If desired, depending on the sea-
son, the heater on the unit can be
disabled. The unit will operate in
the same fashion, with remainder
of the controls.
Pressing the
on the unit at the same time and
holding for 2 seconds will disable
button
on the unit,
and buttons
www.dimplex.com