Jumpers Setup - ASROCK K8 Combo-Z User Manual

2.6

Jumpers Setup

The illustration shows how jumpers are
setup. When the jumper cap is placed on
pins, the jumper is "Short". If no jumper cap
is placed on pins, the jumper is "Open". The
illustration shows a 3-pin jumper whose pin1
and pin2 are "Short" when jumper cap is
placed on these 2 pins.
Jumper
PS2_USB_PWR1
(see p.9, No. 1)
Note: To select +5VSB, it requires 2 Amp and higher standby current provided by
power supply.
JR1 / JL1 Jumper
(see p.9, No. 27)
Note: If the jumpers JR1 and JL1 are short, both the front panel and the rear panel
audio connectors can work.
Clear CMOS Jumper
(CLRTC1)
(see p.9, No. 14)
Note: CLRTC1 allows you to clear the data in CMOS. The data in CMOS includes
system setup information such as system password, date, time, and system
setup parameters. To clear and reset the system parameters to default setup,
please turn off the computer and unplug the power cord, then use a jumper
cap to short pin2 and pin3 on CLRTC1 for 3 seconds. Please remember to put
the jumper cap back to the default setting (short pin1 and pin2) after clearing
the CMOS.
This Manual: http://www.manuallib.com/file/2448158
Setting
1_2 2_3
+5V +5VSB
JR1 JL1
1_2 2_3
Default Clear CMOS
1 7
Short pin2, pin3 to enable
+5VSB (standby) for PS/2 or
USB wake up events.