Using Pro-Clean Reservoir Pad - iRobot Braava 300 Series Owner's Manual

Using the Pro-Clean Reservoir Pad
(Also available as an accessory)
The Pro-Clean Reservoir Pad dispenses liquid as Braava mops to keep
the cleaning cloth wet longer.
Fill the reservoir
1. Open the fill cap by pulling and swiveling it
to the side.
2. Fill reservoir with water and replace fill
cap, pressing it in securely so it does not
leak. Visit global.irobot.com for information
about other cleaning solutions.
3. Fill the reservoir over a sink as a small
amount of fluid can leak out when the fill
cap is closed.
4. Dampen the blue Pro-Clean microfibre
cloth and press onto the velcro strips.
Do not use a dry cloth.
TIP: Fluid dispenses at different rates depending on floor type and solution
used. The first time you mop, start with the cloth only slightly damp
and then increase the starting cloth wetness if needed.
NOTICE: To avoid the Pro-Clean Reservoir Pad leaving excess fluid
on your floor, do not leave Braava unattended when mopping and
remove from floor once Braava stops cleaning.
When mopping is finished:
• Empty any remaining fluid from the reservoir.
• Leave the fill cap open to allow reservoir to dry completely.
Do not store the pad on Braava if wet.
• See page 22 for care instructions.
global.irobot.com
19