Haier LEF65V200S Operating Instructions Manual page 33

Table of Contents

Advertisement

Available languages

Available languages

Operation with the Buttons on the TV
Press
button to decrease the volume or
button to increase the volume, so a volume level scale
(slider) will be displayed on the screen. Press P/CH +
button to select the next programme or P/CH
- button to select the previous programme.
Press the
or
same time to view the main menu. In the
Main menu select a sub-menu using TV/AV
button and set the sub-menu using
or
buttons. To see what options are
available via the menu, refer to the menu
system section of this manual. Press the TV/
AV button in the control panel on the TV to
switch between AV modes.
Note: Function indications of the buttons will be
displayed on the screen when pressed.
Operation with the Remote Control
Press the MENU button on your remote control to
display the main menu screen. Use the " " or "
" buttons to select a menu tab and press the OK
button to select option. Use the " " or " " or " " or
" " buttons to select or set an item. Press BACK or
EXIT or MENU button to quit a menu screen.
Input Selection
Once you have connected external systems to your
TV, you can switch to different input sources. Press
the "
"(source) button on your remote control
consecutively to select the different inputs.
Changing Channels and Volume
You can change the channel and adjust the volume
by using the V+/- and P+/- buttons on the remote. You
can also change the channels by pressing the buttons
on the front panel of your TV.
Inserting the Batteries into the Remote
Lift the cover on the back of the remote upward
gently. Install two AAA batteries. Make sure to
match the + and - ends of the batteries in the
battery compartment (observe the correct polarity)
Replace the cover.
button at the
English - 29 -
Connect Power
IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.
Antenna/Cable Connection
Connect the aerial or cable TV plug to AERIAL INPUT
(ANT-TV) socket located on the rear bottom side of
the TV.
Notification
Manufactured under license from Dolby Laboratories.
TRADEMARK ACKNOWLEDGMENT
"Dolby" and the double-D symbol are trademarks of
Dolby Laboratories.
"HDMI, the HDMI logo and High-Definition Multimedia
Interface are trademarks or registered trademarks of
HDMI Licensing LLC."
"DLNA, the DLNA Logo and DLNA CERTIFIED are
trademarks, service marks, or certification marks of
the Digital Living Network Alliance."
"YouTube and the YouTube logo are trademarks of
Google Inc."
For DTS patents, see http://patents.dts.com.
Manufactured under license from DTS Licensing
Limited. DTS, the Symbol, & DTS and the Symbol
together are registered trademarks, and DTS
TruSurround is a trademark of DTS, Inc. © DTS, Inc.
All Rights Reserved.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents