Shroud; Cleaning The Air Filter - Stihl MS 261 Instruction Manual

Shroud

Removing the shroud
Move the Master Control lever to the
N
stop position (0).
Push the hand guard forward – the
N
chain is locked.
2
1
Open the twist locks (1) by turning
N
them 1/4 turn counterclockwise with
the combination wrench.
Remove the shroud (2).
N
Installing the shroud
Place the shroud in position.
N
Close the twist locks by turning
N
them a 1/4 turn clockwise.
MS 261

Cleaning the Air Filter

If there is a noticeable loss of engine
power
Remove the shroud – see "Shroud".
N
Removing the air filter
Clean away loose dirt from around
N
the filter.
1
NOTICE
To avoid damaging the filter, do not use
tools for removing and installing the air
filter.
1
1.
2.
Rotate the air filter a 1/4 turn
N
counterclockwise and lift it away in
the direction of the rear handle.
Always replace damaged filters.
N
Cleaning the air filter
Wash the filter in STIHL special
N
cleaner (special accessory) or a
clean, non-flammable solution (e.g.
warm soapy water). Rinse the filter
from the inside outwards under a jet
of water – do not use a pressure
washer.
Dry the filter components – do not
N
expose to high temperatures.
Do not impregnate the filter with oil.
N
Reinstall the air filter.
N
Installing the air filter
1.
2.
Place the air filter in position.
N
Push the air filter in the direction of
N
the filter housing and turn it
clockwise at the same time until it
engages – the "STIHL" name must
be horizontal.
Install the shroud – see "Shroud".
N
English
43