Switching On And Off - Meridian 508 User Manual

Switching on and off

During normal use the CD player should be left in the standby
state. This uses a negligible amount of electricity, but ensures
that the components of the CD player operate at maximum
efficiency from the moment you start playing a disc.
If you are not going to use the CD player for a period of several
days you should switch the unit completely off, at the back
panel, and disconnect it from the AC power supply.
To switch on from standby
Press Open (front panel only), > (Play), • (Stop), or =
(Pause).
Switch on any other equipment connected to the CD player
which is not part of the Meridian 500 Series.
To insert a disc
Press Open (front panel only) to open the drawer.
Place your disc, label side up, over the hub, as shown
opposite.
Press Open again to close the drawer.
To switch to standby
Press Off.
The display will show:
If you have other Meridian 500 Series equipment connected to
the CD player, these units will also switch to standby.
If a disc is currently playing, switching to standby will stop the
disc, and the disc can safely be left in the unit.
.
9