Table of Contents
Advertisement
Available languages
Available languages
ENGLISH
Warning!
•
This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety.
•
Do not recharge non-rechargeable batteries.
•
Children should be supervised to ensure that they do not
play with the appliance.
•
Use your Black & Decker charger only to charge the
bat-tery in the tool with which it was supplied. Other
batteries could burst, causing personal injury and
damage.
•
Never attempt to charge non-rechargeable batteries.
•
Have defective cords replaced immediately.
•
Do not expose the charger to water.
•
Do not open the charger.
•
Do not probe the charger.
Additional safety instructions for batteries.
•
Turning the LED light off when not in use as this will
drain the battery.
•
Never attempt to open for any reason.
•
Do not expose the battery to water.
•
Do not store in locations where the temperature may
exceed 40 °C.
•
Charge only at ambient temperatures between 10 °C
and 40 °C.
•
Charge only using the charger provided with the tool.
•
When disposing of batteries, follow the instructions given
in the section "Protecting the environment".
Do not attempt to charge damaged batteries.
Labels on tool
The following pictograms are shown on the tool:
6
Warning! To reduce the risk of injury, the user must
read the instruction manual.
The charger is intended for indoor use only.
Read this entire manual carefully before using the
appliance.
Electrical safety
Your charger is double insulated; therefore no earth
wire is required. Always check that the mains
voltage corresponds to the voltage on the rating
plate. Never attempt to replace the charger unit with a regular
mains plug.
•
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Product Features
1. Keyless chuck
2. Gear box
3. LED
4. LED switch
5. Housing
6. Switch
7. Reverse-rotation lever
8. Handle casing
9. Pivot release button
10. Charging hole
Charging the Battery
Charging as shown,Must turn off the screwdriver.Only Red
lights up on the power indicator when you charging. Charging
time: 3-5Hours. The charger wire plug-in The position of the
machine round hole,The charger plug in the socket. As
shown in the figure B.
Power indicator light
Three different colors of light(From Left:Green.Yellow.Red)
Charging State:
Hide quick links:
Advertisement
Table of Contents
