Loading And Storing; Certification Label; Instructions - Mercedes-Benz 2010 GLK-Class Operator's Manual

X
Switch on the ignition.
X
Push and hold the roof panel switch in
direction of arrow ; (
roller sunblinds are fully retracted.
X
Push and hold the roof panel switch in
direction of arrow ; until the tilt/sliding
panel is opened approximately 4 inch
(10 cm).
X
Pull and hold the roof panel switch in
direction of arrow = until the tilt/sliding
panel is fully closed.
X
Keep holding the roof panel switch in
direction of arrow = for approximately
1 second.
X
Pull and hold the roof panel switch in
direction of arrow = (
roller sunblinds are fully extended.
X
Keep holding the roof panel switch in
direction of arrow = for approximately
1 second.
X
Check the express operation feature of the
tilt/sliding panel ( Y
If the tilt/sliding panel opens completely,
the roof is synchronized. Otherwise repeat
the above steps.

Loading and storing

Loading instructions
G
Warning!
Always fasten items being carried as securely
as possible using cargo tie-down rings and
fastening materials appropriate for the weight
and size of the load.
In an accident, during hard braking or sudden
maneuvers, loose items will be thrown around
inside the vehicle. This can cause injury to
vehicle occupants unless the items are
securely fastened in the vehicle.
To help avoid personal injury during a collision
or sudden maneuver, exercise care when
transporting cargo. Do not pile luggage or
cargo higher than the seat backrests.
Y
page 184) until the
Y page 184) until the
page 185).
Loading and storing
Never drive a vehicle with the tailgate open.
Deadly carbon monoxide (CO) gases may
enter vehicle interior resulting in
unconsciousness and death.
Load distribution
The Gross Vehicle Weight (GVW) is the weight
of the vehicle including:
fuel
R
tools
R
spare wheel
R
installed accessories
R
passengers
R
luggage/cargo
R
It must never exceed the load limit and the
Gross Vehicle Weight Rating (GVWR) for your
vehicle. The load limit and the GVWR are
specified on the placard located on the
driver's door B-pillar (
In addition, the load must be distributed so
that the weight on each axle never exceeds
the Gross Axle Weight Rating (GAWR) for the
front and rear axle. The GVWR and GAWR for
your vehicle are indicated on the certification
label located on the driver's door B-pillar
( Y page 227).
For more information, see "Tire and Loading
Information" ( Y page 228).
The handling characteristics of a fully loaded
vehicle depend greatly on the load
distribution. It is therefore recommended to
load the vehicle according to the illustration
Y page 227).
Z
187