Menu; Telephone - Mercedes-Benz 2009 R-Class Operator's Manual

2009 r-class
Table of Contents

Advertisement

Distance to empty
X
Press button
or
repeatedly until
ÿ
è
the message From Start appears in the
multifunction display.
X
Press button
or
repeatedly until
j
k
the message Range: appears in the
multifunction display.
The calculated remaining driving range
based on the current fuel tank level
appears in the multifunction display.
If only very little fuel is left in the tank, a
vehicle at the fuel pump
¿
instead of the remaining driving range.
Telephone menu
G Warning!
A driver's attention to the road must always
be his/her primary focus when driving. For
your safety and the safety of others, we
recommend that you pull over to a safe
location and stop before placing or taking
a telephone call. If you choose to use the
telephone while driving, please use the
hands-free device and only use the
telephone when weather, road and traffic
conditions permit.
appears
Some jurisdictions prohibit the driver from
using a mobile phone while driving a
vehicle.
Bear in mind that at a speed of just 30 mph
(approximately 50 km/h), your vehicle is
covering a distance of 44 feet
(approximately 14 m) every second.
Never operate radio transmitters equipped
with a built-in or attached antenna (i.e.
without being connected to an external
antenna) from inside the vehicle while the
engine is running. Doing so could lead to a
malfunction of the vehicle's electronic
system, possibly resulting in an accident
and/or personal injury.
Controls in detail
Control system
You can connect your telephone to the
COMAND system via Bluetooth
separate COMAND system operating
instructions.
X
Switch on the COMAND system.
Refer to separate COMAND system
operating instructions.
X
Press button
or
repeatedly until
ÿ
è
the message TEL appears in the
multifunction display.
One of the following messages will appear
in the multifunction display:
No Service: No network is available.
R
Bluetooth Ready: The telephone has
R
not been connected to the COMAND
®
system via Bluetooth
yet.
X
Connect the telephone to the
COMAND system via Bluetooth
Ready or name of the network provider
R
(if available): The telephone has found a
network and is ready for use. You can
operate it using the control system.
Answering a call
When your telephone is ready to receive calls,
you can answer a call at any time. In the
®
, see
®
.
Z
161

Advertisement

Table of Contents
loading

This manual is also suitable for:

2009 r320 bluetec2009 r350R-class 2009R350 2009R320 2009

Table of Contents