Personalisations; Setting The Temperature; Setting The Spin Speed; Functions - Indesit WIXL 86 Instructions For Use Manual

Personalisations

Setting the temperature

Turn the TEMPERATURE knob to set the wash temperature (see Programme table on page 18).
The temperature can be lowered, or even set to a cold wash ( ).

Setting the spin speed

Turn the SPIN SPEED knob to set the spin speed for the programme selected.
The maximum spin speeds for each programme are as follows:
Programmes Maximum spin speed
Cotton 800 rpm
Synthetics 800 rpm
Wool 600 rpm
Silk no
The spin speed can be lowered, or the spin cycle can be excluded altogether by selecting symbol
The washing machine will automatically prevent you from selecting a spin speed higher than the maximum
speed for each programme.
Note: To avoid excessive vibrations, before every spin cycle the machine distributes the load in a uniform manner by
continuously rotating the drum at a speed which is slightly faster than the normal washing speed.
When, despite repeated attempts, the load is still not evenly distributed, the machine spins at a lower speed than
the set frequency.
If the load is excessively unbalanced, the machine attempts to distribute it instead of spinning.
The balancing attempts may extend the total duration of the cycle, up to a maximum of 10 minutes.

Functions

To enable a function:
1. press the button corresponding to the desired function, according to the table below;
2. the function is enabled when the corresponding button is illuminated.
Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the
programme set.
Function Effect
Delays the start
of the wash by
up to 9 hours.
Delay Timer
Allows you to
perform a Pre-
wash
Pre-wash
Bleaching cycle
designed to
remove the
Stain
toughest stains.
removal
This option
reduces the
amount of
Easy iron creasing on
fabrics, making
them easier to
iron.
Comments
Press the button repeatedly until the LED corresponding to the
desired delay is turned on.
The fifth time the button is pressed, the function will be disabled.
N.B.: Once you have pressed the Start/Reset button, the delay
can only be decreased if you wish to modify it.
It can be used on all Programmes excluded the Wool programme
and the Special Wash programme (see page 18).
This function is incompatible with the STAIN REMOVAL function.
Please remember to pour the bleach into extra compartment 4
(see page 20).
This function is incompatible with the EASY IRON function.
When this function is set, programmes 4, 5, 7 will end with the
laundry left to soak (Anti-crease) and the Rinse cycle phase
LED will flash.
- to conclude the cycle, press the START/RESET button;
- to run the draining cycle alone, set the knob to the relative
symbol and press the START/RESET button.
This function is incompatible with the STAIN REMOVAL function.
GB
.
Enabled with
programmes:
All
1, 2, 3, 4, 5, 7
1, 2, 3, 4, 5,
Rinse cycle.
3, 4, 5, 7, 8,
9, 10, Rinse
cycle.
19