Sanyo VCC-4372P Instruction Manual page 9

MOUNTING THE LENS
1
2
2 1
2
1
3
4
4 3
Rewiring the lens cable in the lens iris plug
1
Prepare the lens cable.
Cut the cable at the plug, then remove approx. 8 mm of the cable sheath and strip about 2 mm from each
wire.
2
Install the lens iris plug.
Solder the cable to the pins following the correct pin layout (refer to the table and illustrations), then close
the plug cover.
Pin layout
DC type lenses
1 Brake coil (–) +12 V DC (50 mA max.)
2 Brake coil (+) Not used
3 Drive coil (+) Video output (1.0 Vp-p, high impedance)
4 Drive coil (–) Ground (for video signal and DC power)
VIDEO type lenses
8
English