Parts Names - Sanyo VCC-4372P Instruction Manual

PARTS NAMES

4
1
NC + –
2
G C B
3 5
6
7
A
3
English
1
Power indicator (POWER)
Comes on when the power to the camera is on.
2
Video output connector (VIDEO OUT: BNC type)
Connect this connector to a device such as a VCR or monitor with a VIDEO IN connector.
3
Control terminal (CONTROL)
Manual colour/black and white setting
• G (ground) terminal
• C (colour) terminal
•
B (black and white) terminal
4
External sync composite video signal input connector (VBS IN: BNC type)
Connect to this connector the synchronizing signal output from a synchronizing signal device or the composite
signal of a video distributor.
5
12 V DC input terminal (12 V DC, NC)
6
Camera setup section (under the cover)
These settings are for when using a 1/3 inch CS mount DC (without EE internal amplifier) type lens. However,
if due to installation conditions or environment the settings may need to be modified for best results (see
"SETTINGS").
To access the controls, loosen the cover fixing screw A, then remove the cover.
7
Lens iris output connector (LENS)
This 4-pin connector is used to send the DC control signal and power supply to an auto-iris type lens.