Procedure To Disable Immobilizer Engine Block Through Throttle Twistgrip - Ducati Super Sport SS800 Owner's Manual

Procedure to disable immobilizer engine
block through throttle twistgrip
1) Turn the key to ON and fully open throttle. Keep it open.
The EOBD warning light (7, fig. 4.2) turns off after 8
seconds.
2) Release the throttle as soon as the EOBD warning light
turns off.
3) EOBD pilot light will flash. It is now necessary to enter
the electronic code indicated on the CODE CARD
delivered to the customer together with the bike.
4) Count as many flashes of the EOBD pilot light (7, fig.
4.2) as the first digit of the electronic code.
Fully open the throttle for 2 seconds, and release. In
this way the input of one figure is acknowledged, EOBD
pilot light comes on and stays on for 4 seconds. Carry
out the same procedure for the following figures of the
code. Failure to comply with this procedure, the EOBD
pilot light will flash for 20 times, then will come on
steady. Repeat the procedure starting from step (1).
5) Release the throttle twistgrip, if the code is correct, the
EOBD warning light shall flash signalling that engine
block has been disabled. The warning light turns off
after 4 seconds.
6) If the code is NOT correct, the EOBD warning light stays
on and it is then possible to turn the key to OFF and
repeat the procedure, starting from point (1), as many
times as necessary (infinite).
Note
Should the throttle twistgrip be released before the set
time, the warning light turns on again. It is then necessary to
bring the key to OFF and restart the procedure from point (1).
E
17