Network Setup; Software Version; Software Update; Save Settings - Krell Industries Foundation Processor Owner's Reference Manual

Network Setup

Press the Enter button to enter the Network Setup sub menu. Press the up or down button to view the various
network parameters. Press the Enter button to see the value for the displayed parameter.
IP Address: The default network discovery is DHCP. If the Foundation is connected to an active network, it
automatically acquires an IP address. To enter an IP address manually, change the Foundation to Static IP operation.
To change to Static IP operation, press the Enter button at the IP Address sub menu. Press the Up or Down button to
change the setting to Static. Press the Enter button to display the IP address. Press the Right button to move the cursor
to number to be edited. Press the Enter button again and the selected number of the IP Address will begin blinking.
Use the Up or Down button to edit the IP Address value. Press the Enter button to confirm change. Press the Left or
Right button to move the cursor to another number in the IP address and repeat editing process.
Use the same process to edit the other network settings.
Note: the MAC Address is a factory set value and is not user editable.
Diagnostic Mode
Diagnostic mode is used for troubleshooting and is disabled as a default. Leave diagnostic mode disabled unless
directed by Krell.

Software Version

Press the Enter button to view currently operating Foundation software

Software Update

Press the Enter button to display the Software Update sub menu. Press the Up or Down button to select the method
for updating the software. Press the Enter button to select and then the Enter button again to confirm.
Choose the USB option if the Foundation is not connected to the internet and software updates are to be performed
by connecting a USB drive to the USB input on the rear panel of the Foundation.
Choose the Network option if the Foundation is connected to the internet. The Foundation will check the Krell
update server to determine if a new software update is available.
Restore Settings
Restore Settings will return the Foundation to the original factory settings or to previously saved user settings. Press
the Up or Down button to change to User. Press the Enter button to confirm selection. Press the Enter button again
to return to factory or user saved settings. The Foundation will display various messages and will eventually return to
the standby mode.

Save Settings

Save Settings will save all configuration settings in non volatile memory. Press the Enter button to begin saving
process.
Foundation Processor 13