First Alert DC10-500 User Manual page 21

Modular Devices FCC and Industry
Canada Compliance Statements
OEM Responsibilities to comply with FCC and Industry Canada Regulations
The BLEMOD1 Module and AW-CU300 Module have been certified for integration into products only by OEM
integrators under the following condition:
1. The transmitter module must not be co-located or operating in conjunction with any other antenna or
transmitter.
As long as the condition above is met, further transmitter testing will not be required. However, the OEM integrator
is still responsible for testing their end-product for any additional compliance requirements required with this
module installed (for example, digital device emissions, PC peripheral requirements, etc.).
IMPORTANT:
! location with another transmitter), then the FCC and Industry Canada authorizations are no longer
considered valid and the FCC ID and IC Certification Number cannot be used on the final product.
In these circumstances, the OEM integrator will be responsible for re-evaluating the end product
(including the transmitter) and obtaining a separate FCC and Industry Canada authorization.
End Product Labeling
The BLEMOD1 Module and AW-CU300 Module are labeled with their own FCC ID and IC Certification Number. If
the FCC ID and IC Certification Numbers are not visible when the module is installed inside another device, then the
outside of the device into which the module is installed must also display a label referring to the enclosed module.
In that case, the final end product must be labeled in a visible area with the following:
"Contains Transmitter Modules FCC ID: M7U-BT1IOT and FCC ID: TLZ-CU300"
"Contains Transmitter Modules IC: 10190A-BT1IOT and IC: 6100A-CU300"
Or
"Contains FCC ID: M7U-BT1IOT and FCC ID: TLZ-CU300"
"Contains IC: 10190A-BT1IOT and IC: 6100A-CU300"
The OEM of the BLEMOD1 Module and AW-CU300 Module must only use the approved antenna(s) listed above,
which have been certified with this module. The OEM integrator has to be aware not to provide information to the
end user regarding how to install or remove this RF module or change RF related parameters in the user manual of
the end product.
To comply with FCC and Industry Canada RF radiation exposure limits for general population, the antenna(s) used
for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
In the event that these conditions cannot be met (for certain configurations or co-
21