Maintenance - Briggs & Stratton 290000 Series Operating & Maintenance Instruction Manual

Maintenance

Regular maintenance will improve the performance and
extend the life of the engine. See any Authorized Briggs
& Stratton Dealer for service. Use only genuine Briggs
& Stratton parts. Other parts may not perform as
well, may damage the engine, and may result in
injury. In addition, use of other parts may void your
warranty.
Emission Control
Maintenance, replacement or repair of the emission
control devices and systems may be performed by
any nonroad engine repair establishment or
individual. However, to obtain no charge repairs under
the terms and provisions of the Briggs & Stratton
warranty statement, any service or emission control part
repair or replacement must be performed by a factory
authorized dealer.
CAUTION
All the components used to build this engine
assembly must remain in place for the proper
operation of this engine.
Follow the instructions and schedules indicated below.
Task Every 8 Hours
Perform task at hourly
or calendar interval,
whichever comes first.
Check Oil Level
Service Air Cleaner Pre-Cleaner*
**
Change Oil
Inspect Spark Arrester (if equipped)
Change Oil Filter (if equipped)
Service Air Cleaner Cartridge*
Clean Oil Cooler (if equipped)*
Clean Cooling System*
Check Valve Clearance on LPG/NG Engines
Clean/Replace Spark Plugs
Clean/Replace In-line Fuel Filter (if equipped)
Check Valve Clearance
* Clean more often under dusty conditions or when airborne debris is present. Replace air cleaner, if very dirty.
** Change oil after first 5 to 8 hours of use, then every 50 hours. Change oil every 25 hours when operating the
engine under heavy load or in high temperatures.
25
or Daily Hours
WARNING
Unintentional sparking can result
in fire or electric shock.
Fire or explosion can cause
severe burns or death.
Unintentional start-up can result
in entanglement, traumatic
amputation, or laceration.
Before performing maintenance or repairs:
• Disconnect spark plug wire and keep it away
from spark plug.
• Disconnect battery at negative terminal (only
engines with electric start).
• Use only correct tools.
•
Do not strike the flywheel with a hammer or hard
object because the flywheel may later shatter
.
during operation
•
Do not tamper with governor spring, links or
other parts to increase engine speed
When testing for spark:
• Use approved spark plug tester.
• Do not check for spark with spark plug removed.
50 100
Hours Hours
.
100 − 400
Hours
11