Baud Rate D I P Switch Settings - Radio Shack TRS-80 CR-510 Operation Manual

Setting the DIP Switches
At the rear of the CR-510 are the DIP Switches which let you set the baud rate. The CR-510's baud
rate must match that of the Computer it is connected to. For example, if you have set the baud
rate of a TRS-80 Model III to 4800 baud, you must set the CR-510's DIP Switches to the 4800
baud setting.
There are four numbered DIP switches on the CR-510. The LEFT/RIGHT setting combination of the
four switches determines the baud rate. Use a small screwdriver or a pair of tweezers to position
the switches.
If all of the switches are set to the LEFT, for instance. 50 is the baud rate. If switches 1 and 4 are to
the RIGHT and 2 and 3 are to the LEFT, 2000 is the baud rate, as shown in Figure 7. See Table 1.
Remember! 0= LEFT. 1 = RIGHT.
Figure 6B. Card Retainer Installation