Asus P5Q-E Hardware User Manual page 165

Using Drive Xpert function in BIOS setup environment
You may use Drive Xpert function in BIOS setup environment. To enter BIOS
setup, press DEL key after powering on. Drive Xpert configuration options are
under Tools menu.
Before using the Drive Xpert function, ensure that you have back up all your
data in your hard disks.
• EZ Backup erases all original data in the hard disk connected to the
SATA_E2 (white, port 1) connector on the motherboard.
• Super Speed erases all original data in both hard disks.
Main Ai Tweaker
ASUS EZ Flash 2
Drive Xpert Control
Drive Xpert Mode Update
Update To Super Speed
Update To EZ Backup
Update To Normal Mode
Express Gate
Enter OS Timer
Reset User Data
ASUS O.C. Profile
AI Net 2
v02.61 (C)Copyright 1985-2008, American Megatrends, Inc.
Drive Xpert Control [Auto]
This item allows you to enable or disable the Drive Xpert function.
Configuration options: [Auto] [Enabled] [Disabled]
Drive Xpert Mode Update [Last Setting]
This item appears only when you set Drive Xpert Control to [Auto] or
[Enabled]. Set this item to [Mode Change] to show further settings of the
Drive Xpert function. Configuration options: [Last Setting] [Mode Change]
The following items appear only when you set Drive Xpert Mode Update to
[Mode Change].
Update To Super Speed [Press Enter]
This item allows you to use Super Speed function. Plug two identical SATA hard
drives in the SATA_E1 (orange, port 0) and SATA_E2 (white, port 1) connectors on
the motherboard and press the <Enter> key.
Update To EZ Backup [Press Enter]
This item allows you to use allows you to use EZ Backup function. Plug two identical SATA hard
drives in the SATA_E1 (orange, port 0) and SATA_E2 (white, port 1) connectors on
the motherboard and press the <Enter> key.
Update To Normal Mode [Press Enter]
This item allows you to use the SATA_E1 (orange, port 0) and SATA_E2 (white, port 1)
connectors as normal SATA connectors. as normal SATA connectors.
When using one hard disk in Normal Mode, connect the hard disk to the
SATA_E1 (orange, port 0) connector on the motherboard.
ASUS P5Q-E
BIOS SETUP UTILITY
Advanced
[Auto]
[Mode Change]
[Press Enter]
[Press Enter]
[Press Enter]
[Enabled]
[10 Seconds]
[No]
[Auto] [Enabled] [Disabled] [Enabled] [Disabled]
and press the <Enter> key.
SATA_E1 (orange, port 0) and SATA_E2 (white, port 1) connectors on
and press the <Enter> key.
the SATA_E1 (orange, port 0) and SATA_E2 (white, port 1)
Power Boot
SATA_E2 (white, port 1) connectors on
. Plug two identical SATA hard
Tools Exit
Press ENTER to run
the utility to select
and update BIOS.
This utility doesn't
support :
1.NTFS format
Select Screen
Select Item
Enter Go to Sub Screen
F1 General Help
F10 Save and Exit
ESC Exit
connectors on connectors on
4-49