Lexus 2013 GS 350 Owner's Manual page 67

Tire inflation pressure (if equipped)
■
It may take a few minutes to display the tire inflation pressure after the engine
●
switch is turned to IGNITION ON mode. It may also take a few minutes to display
the tire inflation pressure after inflation pressure has been adjusted.
"---" may be displayed if the tire information cannot be determined due to unfavor-
●
able radio wave conditions.
Tire inflation pressure changes with temperature. The displayed values may also be
●
different from the values measured using a tire pressure gauge.
Liquid crystal display
■
Small spots or light spots may appear on the display. This phenomenon is character-
istic of liquid crystal displays, and there is no problem continuing to use the display.
Customization
■
Setting of available languages can be changed. (Customizable features
CAUTION
The information display at low temperatures
■
Allow the interior of the vehicle to warm up before using the liquid crystal informa-
tion display. At extremely low temperatures, the information display monitor may
respond slowly, and display changes may be delayed.
For example, there is a lag between the driver' s shifting and the new gear number
appearing on the display. This lag could cause the driver to downshift again, caus-
ing rapid and excessive engine braking and possibly an accident resulting in death
or injury.
Cautions during setting up the display
■
As the engine needs to be running during setting up the display, ensure that the
vehicle is parked in a place with adequate ventilation. In a closed area such as a
garage, exhaust gases including harmful carbon monoxide (CO) may collect and
enter the vehicle. This may lead to death or a serious health hazard.
NOTICE
During setting up the display
■
To prevent battery discharge, ensure that the engine is running while setting up the
display features.
GS350_U (OM30C34U)
2. Instrument cluster
I n f o r ma t i o n P r o v i d e d b y :
2
P. 777)