Lorex NTSC Instruction Manual page 14

Camera Operation
5) When a name has been chosen, please select a position for the name
display.
Please move the cursor onto 'POS' and then press the SETUP button.
The name will appear at the top left
corner.
Please find the position you wish to
display the name by using the 4
directional buttons, and then press the
SETUP button.
6) Please select 'END' and then press the SETUP button to complete ID input.
COLOR
- AUTO : This camera has a function which automatically changes to
the appropriate mode for daytime or night-time. The COLOR
mode is operated for daytime, and it converts to BW mode for
night-time.
- ON : The color mode is selected by default, and the modes do not
change automatically.
26
Digital Day&Night Vandal Dome
Note
• When the AGC is turned off, COLOR does not operate.
• When an infrared light is used, there may be a problem with focusing.
Two SYNCHRONIZATION modes are available INTERNAL and
SYNC :
EXTERNAL LINE-LOCK. In LINE-LOCK mode, it synchronizes the
video signal between cameras without a synchronous generator.
The line-lock synchronization is only used in the areas of 60Hz
(NTSC Models) / 50Hz (PAL Models).
- INT : Internal synchronization
- LL : External line-lock synchronization
• If you choose 'LL', you can adjust the desired phase.
Press the SET button.
• You can adjust the desired phase from 0 to 359.
Note
• When the power frequency is 50Hz, you can not use the line-lock mode (NTSC Models).
• When the power frequency is 60Hz, you can not use the line-lock mode (PAL Models).
• 'Sync.' mode is fixed to 'INT' in DC 12V input power.
27
Digital Day&Night Vandal Dome