Installation; Installation Requirements - Friedrich UE08A13A Service And Parts Manual

3. INSTALLATION

3.1 INSTALLATION REQUIREMENTS

If you use an existing wall sleeve, you should measure its
dimensions.
Install the new air conditioner according to these installation
instructions to achieve the best performance. All wall sleeves
used to mount the new air conditioner must be in good
structural condition and have a rear grille to securely attach
the new air conditioner. (FIG. 19A)
With the FRIEDRICH USC sleeve, you can maintain the
best performance of the new air conditioner. (FIG. 19B)
19- / "
21
32
(499 mm)
Air Conditioner
Expanded
aluminum metal grille
FRIEDRICH Wall Sleeve
ELECTRICAL SERVICE
Check your available electrical service. The power supply
available must be the same as that shown on the unit
nameplate (found on left side of cabinet).
All models are equipped with a 3-prong service plug to
provide proper service and safe positive grounding. Do not
change plug in any way. Do not use an adapter plug. If your
present wall outlet does not match your plug, call a qualified
electrician to make the necessary corrections. SAVE
CARTON for storage and this OWNER'S MANUAL for future
reference. The carton is the best way to store unit during
winter or when not in use.
24- / "
21
32
(626 mm)
14- 13 / "
32
(366 mm)
18"(458 mm)
FIG. 19A
25- 7 / "
8
(656 mm)
15- 17 / "
32
(394 mm)
16- 23 / "
32
(425 mm)
FIG. 20B
INSTALLATION HARDWARE
1
8
ITEM NAME OF PARTS
1 PLASTIC GRILLE
2 HORIZONTAL INSULATION STRIPS
3 AROUND INSULATION STRIPS
4 SUPPORT BLOCK
5 BAFFLE
6 TRIM FRAME
7 SHIM
8 PLASTIC NUTS AND WASHER SCREWS
To avoid risk of personal injury, property damage, or
product damage due to the weight of this device and sharp
edges that may be exposed:
• Air conditioners covered in this manual pose an
excessive weight hazard. Two or more people are
needed to
To prevent injury or strain, use proper lifting and carrying
techniques when moving unit.
• Carefully inspect location where air conditioner will be
installed. Be sure it will support the weight of the unit
over an extended period of time.
• Handle air conditioner with care. Wear protective gloves
whenever lifting or carrying the unit. AVOID the sharp
metal fins of front and rear coils.
• Make sure air conditioner does not fall during installation.
REQUIRED TOOLS:
• Tight Fitting gloves
• Standard screwdriver
• Phillips screwdriver
• Pliers
• Sharp knife
—15—
2
4
2 Size options
5
7
3
6
2 Size options
CAUTION
move and install
• 3/8-inch open end
wrench or adjustable
wrench
• 1/4-inch hex socket
and ratchet
• Tape measure
• Electric drill
• 1/4-inch drill bit
Q'TY
1
2
2
2
1
2
2
4
the unit.