Error Information Page - Panasonic PT-DZ21K2 Operating Instructions Manual

Error information page

When [Error (Detail)] or [Warning (Detail)] is displayed in the [SELF TEST] display field of the [Projector status]
screen, click it to display the content of the error/warning.
f The projector may go into the standby status to protect the projector depending on the contents of the error.
1 Self-diagnosis result display
Displays the item check results.
[OK]:
Indicates that operation is normal.
[FAILED]:
Indicates that there is a problem.
[WARNING]:
Indicates that there is a warning.
r [FAILED] items
Item
[MAIN CPU BUS]
[FAN]
[INTAKE AIR TEMPERATURE]
[OPTICS MODULE TEMPERATURE]
[EXHAUST AIR TEMPERATURE]
[LAMP1 REMAIN TIME]
[LAMP2 REMAIN TIME]
[LAMP3 REMAIN TIME]
[LAMP4 REMAIN TIME]
[LAMP1 STATUS]
[LAMP2 STATUS]
[LAMP3 STATUS]
[LAMP4 STATUS]
[APERTURE(CONTRAST-SHUTTER)]
[SHUTTER(MUTE-SHUTTER)]
[INTAKE AIR TEMP.SENSOR]
[OPTICS MODULE TEMP.SENSOR]
[EXHAUST AIR TEMP.SENSOR]
[POWER CIRCUIT TEMPERATURE]
[FPGA TEMPERATURE]
[LENS MOUNTER]
[COVER OPEN]
Chapter 4 Settings — [NETWORK] menu
There is a problem with the microcomputer circuitry. Consult your dealer.
There is a problem with the fan or the fan drive circuit. Consult your dealer.
The intake air temperature is high. The projector may be used in an environment where
the temperature is high, such as near a heating appliance.
The temperature around the optics module inside the projector is high. The projector
may be used in an environment where the temperature is high, such as near a heating
appliance.
The exhaust air temperature is high. The projector may be used in an environment
where the temperature is high, such as near a heating appliance. Or the air exhaust port
may be blocked.
The runtime of the lamp has exceeded the specified time, and it is time to replace the
lamp.
The lamp has failed to turn on. Wait a while until the luminous lamp cools off, and then
turn on the power.
There is a problem with the contrast shutter circuitry. Consult your dealer.
There is a problem with the shutter circuitry. Consult your dealer.
There is a problem with the sensor used to detect intake temperature. Consult your
dealer.
There is a problem with the sensor used to detect temperature inside the projector.
Consult your dealer.
There is a problem with the sensor used to detect exhaust air temperature. Consult your
dealer.
The temperature around the power circuit is high. The air intake port may be blocked.
The temperature inside the projector is high. The air intake port may be blocked.
There is a problem in the lens mounter. Consult your dealer.
Installation of the lamp unit cover is incomplete. Check the installation of the lamp unit
cover. (x page 184)
1
Description
ENGLISH - 163