Power Failure; Lower Oven - GE JTP85 Use And Care Manual

Clock
The clock must be set before
the controls for the lower oven
will work.
The time of day clock cannot be
changed during Delay Start. (It can
be changed during a regular bake or
broil operation.)
Timer
You may program the timer to time cooking or other
household activities for up to 9 hours and 59 minutes.
The timer counts down in minutes, 1 minute at a time,
until the last 60 seconds are reached, then the control
will beep one time. The seconds will not be displayed
until the last minute is reached.
How to Set the Timer
1. Press KITCHEN TIMER ON/OFF.
KITCHEN
TIMER
ON OFF
HR/MIN
2. Press the number pads to set the time.
For example, to enter 2 hours and 45
minutes, touch 2, 4 and 5 in that order.
If you make a mistake, press KITCHEN
TIMER ON/OFF and begin again.

Power Failure

If a flashing time is in the display, you have
experienced a power failure. Reset the clock.
20

LOWER OVEN

CONTROL, CLOCK AND TIMER
To Set the Clock
CLOCK
2. Press the number pads the
same way you read them. For
example, to set 12:34, press the
number pads 1, 2, 3 and 4 in
that order.
If number pads are not pressed
within one minute after you
press CLOCK, the display
reverts to the original setting.
If this happens, press CLOCK
and reenter the time of day.
1. Press CLOCK.
When the timer reaches " :00," the control will beep
3 times followed by one beep every 6 seconds until
KITCHEN TIMER ON/OFF is pressed.
The 6 second tone can be canceled by following
the steps in the Special Features of Your Lower
Oven Control section under Tones at the End of a
Timed Cycle.
3. Press START.
After pressing START, "SET" disappears;
START
this tells you the time is counting down,
although the display does not change
until one minute has passed.
4. When time is up, the oven control
KITCHEN
signals until you press KITCHEN
TIMER
ON OFF TIMER ON/OFF. Display then shows
HR/MIN
the time of day.
NOTE: The minute timer is independent of all the
other functions and it does not control the oven.
The CLEAR/OFF pad does not affect the timer.
To reset the clock, press CLOCK. Enter the correct
time of day by pressing the appropriate number pads.
Press START.
3. Press START. This
enters the time and
START
starts the clock.
To check the time of day when
the display is showing other
information, simply press
CLOCK. The time of day shows
until another pad is pressed.