Central Processing Unit (Cpu) - Asus MEL-M 370 User Manual

III. HARDWARE SETUP

3. Central Processing Unit (CPU)

The motherboard provides a ZIF Socket 370. The CPU that came with the mother-
board should have a fan attached to it to prevent overheating. If this is not the case
then purchase a fan before you turn on your system.
WARNING!
Be sure that there is sufficient air circulation across the processor's
heatsink by regularly checking that your CPU fan is working. Without sufficient
circulation, the processor could overheat and damage both the processor and the
motherboard. You may install an auxiliary fan, if necessary.
To install a CPU, first turn off your system and remove its cover. Locate the ZIF
socket and open it by first pulling the lever sideways away from the socket then
upwards to a 90-degree right angle. Insert the CPU with the correct orientation as
shown. The notched corner should point towards the end the of the lever. Because
the CPU has a corner pin for two of the four corners, the CPU will only fit in the one
orientation as shown. The picture is for reference only; you should have a CPU fan
that will cover the face of the CPU. With the added weight of the CPU fan, no force
is required to insert the CPU. Once completely inserted, close the socket's lever
while holding down the CPU.
NOTE: Set the bus frequency and multiple for your Socket 370 processor.
1 0
R
MEL-M
MEL-M Socket 370
1 0 1 0
Socket 370 CPU (Top) Socket 370 CPU (Bottom)
Notch
ASUS MEL-M User's Manual 19