Radio Shack 23-402 User Manual

23-402.fm Page 1 Friday, August 6, 1999 2:40 PM
Quick Charge Battery Charger
Your RadioShack Quick Charge Battery
Charger recharges the 6V nickel-cadmium
battery pack (RadioShack Cat. No. 23-228)
used in Tyco and other 6V radio-controlled
®
vehicles, in 4 hours.
Warnings:
• To reduce the risk of injury, charge only
the specified battery type. Other types of
batteries might burst, causing personal
injury or damage to your charger.
• To reduce the risk of fire or electric shock,
connect the charger directly to a standard
AC power outlet.
• Do not recharge a battery pack that is
damaged or leaking.
• Periodically examine the charger for con-
ditions that might result in a risk of fire,
electric shock, or injury to yourself, chil-
dren, or others. If you observe any breaks
in the housing or other conditions that
appear different than when you first pur-
chased the charger, do not use it until it is
properly repaired by a qualified service
technician.
Cautions:
• After use, the battery pack will be hot.
Wait at least 20 minutes until the battery
pack cools down before recharging it.
Charging a warm or hot battery pack
greatly reduces the number of times your
battery pack can be recharged.
• If the battery pack is wet, thoroughly dry it
before charging.
Note: The running time for radio-controlled
vehicles varies, depending upon which vehicle
you have.
© 1996 Tandy Corporation.
All Rights Reserved.
RadioShack is a trademark used by Tandy Corporation.
®
Tyco is a registered trademark of Tyco industry, Inc.
CHARGING
The battery pack requires a complete charge
before use. Follow these steps for the first and
each subsequent charge.
1. Align the arrow on the bottom of the bat-
tery pack with the arrow on the battery
charger.
2. Gently press the battery pack against the
battery charger, then slide the battery
pack in the direction of the arrow until it
locks into place.
3. Plug the battery charger into a standard
AC outlet.
23-402
Cat. No.