Removing The Control Board - KitchenAid KOMS155MBL Technical Education

REMOVING THE CONTROL BOARD

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug microwave oven or disconnect
power.
2. Open the microwave oven door.
3. Remove the screw from the decorative
panel.
4. Lift the panel and unhook the side tabs,
then pull the panel forward as far as the
wires will allow.
Screw
Decorative
Panel
5. Disconnect the following connectors from
the control board:
a) 3-wire connector from CN-F.
b) 2-wire connector from CN-B.
c) 11-wire connector from CN-C.
d) 5-wire connector (with red & red-brown
wires) from CN-A.
e) Connector with 2 gry & 2 wht wires at
relay RY1.
f) Connector with 2 blk & 2 red wires at
relay RY2.
CN-F
CN-B
CN-A
6. Remove the screw from the control board
and unclip it from the decorative panel.
4-3
CN-C
RY1
RY2
Locking
Clip
Screw