Guided Tour - Sr55 Receiver Rear Panel - Samson Stage 55 Owner's Manual

Guided Tour - SR55 Rear Panel
2 3 4
1
1: DC input - Connect the supplied 12 volt, 250 mA power adapter here, using the strain
relief as shown in the illustration below. WARNING: The substitution of any other kind of
power adapter can cause severe damage to the SR55 and will void your warranty.
-
Using the strain relief: Gather up a loop of wire and pass it through the strain relief,
then pass the adapter plug through the loop in order to create a knot.
2: Balanced output* - Use this electronically balanced low impedance (600 Ohm) XLR
jack when connecting the SR55 to professional (+4) audio equipment. Pin wiring is as
follows: Pin 1 ground (shield), Pin 2 high (hot), and Pin 3 low (cold).
3: Audio Output Level switch - Sets the audio output level attenuation of the balanced
output (see #4 below) to -20 dBm (line level) or -40 dBm (mic level). See the "Setting Up
and Using Your Stage 55 Series / Stage 5 Series System" section on page 12 in this manu-
al for more information.
4: Unbalanced output* - Use this unbalanced high impedance (5K Ohm) 1/4" jack when
connecting the SR55 to consumer (-10) audio equipment. Wiring is as follows: tip hot,
sleeve ground.
* If required, both the unbalanced and balanced outputs can be used simultaneously.
6