Advertisement
Guided Tour - SR5 Rear Panel
1: DC input - Connect the supplied 12 volt, 500 mA power adapter here, using the strain relief
as shown in the illustration below. WARNING: The substitution of any other kind of power
adapter can cause severe damage to the SR5 and will void your warranty.
Using the strain relief: Gather up a loop of wire and pass it through the strain relief,
then pass the adapter plug through the loop in order to create a knot.
2: Balanced output* - Use this electronically balanced low impedance (600 Ohm) XLR jack
when connecting the SR5 to professional (+4) audio equipment. Pin wiring is as follows: Pin 1
ground (shield), Pin 2 high (hot), and Pin 3 low (cold).
3: Audio Output Level switch - Sets the audio output level attenuation of the balanced output
(see #2 above) to -20 dBm (line level) or -40 dBm (mic level). See the "Setting Up and Using Your
Stage 5 Series System" section on page 5 in this manual for more information.
4: Unbalanced output* - Use this unbalanced high impedance (5K Ohm) 1/4" jack when
connecting the SR5 to consumer (-10) audio equipment. Wiring is as follows: tip hot, sleeve
ground.
* If required, both the unbalanced and balanced outputs can be used simultaneously.
3
Advertisement
