Advertisement
LOCATION OF CONTROLS
1. SKIP/SEARCH DOWN Button
2. SKIP/SEARCH UP Button
3. MODE BUTTON
4. PROG (PROGRAM) BUTTON
5. LCD DISPLAY
6. NIGHT LIGHT
7. STOP BUTTON (POWER OFF)
8. VOLUME - BUTTON
9. VOLUME UP BUTTON
10. OPEN BUTTON
11. PHONE JACK
12. DC JACK
13. BATTERY COMPARTMENT
EN-4
POWER SOURCE
This CD player operates on two 1.5V DC 'AA' size (UM-3) alkaline batteries (not
included) or with an AC adaptor with an output of 4.5VDC/700mA (not included).
To install batteries into the player
1. Open the battery compartment cover located on bottom of cabinet.
2. Insert two 1.5V DC 'AA' size (UM-3) alkaline batteries (not included) into the
Battery Compartment following the polarity markings as indicated on the
bottom cabinet.
3. Close the battery door and completely slide it back to its original position.
Battery care
i.
Be sure that the batteries are installed correctly. Wrong polarity may
damage the unit.
ii.
(a) Do not mix old and new batteries.
(b) Do not mix alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries.
iii. If the unit is not to be used for an extended period of time, remove the
batteries. Old or leaking batteries can cause damage to the unit and
may void the warranty.
iv.
Never attempt to charge "Non-rechargeable" batteries.
v.
Do not dispose of batteries in fire, batteries may explode or leak.
Using an adaptor (not included) to power the player
1. Before connecting the adaptor to the player, make sure that the AC voltage of
the adaptor corresponds to your local AC outlet voltage. The polarity of the
adaptor must match to the polarity markings next to the DC jack on the player.
2. Plug the 4.5VDC/500mA AC-DC adaptor into an AC outlet.
3. Insert the DC plug into the jack on the player.
NOTE:
When the adaptor is connected, the batteries will be automatically
disconnected and the player will now operate on the adaptors power.
Once the adaptor is unplugged the player will automatically switch to
back to battery power.
EN-5
Advertisement
