Table of Contents
Advertisement
4.4
Diagnostics Quick Reference Flow Chart cont'd
Press Power
Button
#4 Continuous Cycle Test Mode
Once a mode has been entered, press Power to exit diagnostics
except Display and Show Off modes) which require the plug to be removed from the power socket.
Rinse Aid Adjustments/Tub Open Beep/Water Pressure Setup
LCD Display on. Hold
the Programme and
Eco Touch Switches
simultaneously for
5 seconds
Water Pressure option
is available if water
pressure is below
50kPa and a 'U1'fault
occurs during wash
cycles. If this happens
then change water
pressure setting to 'LP'.
(Factory setting is 'HP'.)
Press
Start/Pause
button
Press Key Lock.
Press Key Lock
Press
Start/Pause
Press
Start/Pause
- 19 -
Continuous
Touchswitch panel is
cycle
Red Red
Select desired cycle and
Continuous cycle is indicated
Stand - by
by backlight alternating
mode
between green & orange. In
this mode the cycle count is
Machine Beeps
and "HP" is
displayed in
the LCD.
This turns the
Smiley Face off &
deactivates Tub
Open
beeps.
This turns the
Smiley Face on &
activates Tub
Open
beeps.
This adjusts
water pressure
set up from high
to low.
This adjusts
water pressure
set up from
low to high
LCD is Rd backlight
and displays CC.
Red Red
operate as normal.
displayed.
Push Wash
Programme Selection
Touch Switch to select
dose of Rinse Aid.
Each LED = 1cc.
Press Power to Exit.
Press Power to
exit
Hide quick links:
Advertisement
Table of Contents
